Controlled-products-systems-group 1044682 User Manual download pdf (Page 21)

Page 21

November, 2003

402 Operator And

455 D Control Panel Installation Manual

THE 455 D CONTROL PANEL INSTALLATION INSTRUCTIONS

ADVANCED PROGRAMMING

+

Display Function De-

fault

M

AXIMUM TORQUE AT INITIAL THRUST:

The motors operate at maximum

torque (ignoring the torque setting)

at start of movement. Useful for

heavy leaves.

4 = Enable

No = Disabled

L

AST STROKE AT CLOSING:

The motors are activated at full

speed for 1s to facilitate locking of

the electric lock.

4 = Enable

No = Disabled

R

EVERSING STROKE:

Before opening, while the gate is

closed, the motors thrust to close

for 2 s thus facilitating release of the

electric lock.

4 = Enable

No = Disabled

L

EAF 2 OPENING DELAY (2S):

Enables delayed start (at opening) of

leaf 2, avoiding interference between

leaves.

4 = Enable

No = Disabled

F

AIL SAFE:

If this function is activated, it en-

ables a function test of the photo-

cells before any gate movement. If

the test fails (photocells not service-

able), the gate does not start the

movement.

4 = Enable

No = Disabled

P

RE FLASHING (5S):

Activates the flashing lamp for 5s

before start of movement.

4 = Enable

No = Disabled

E

LECTRIC LOCK ON LEAF 2:

For using the electric lock on leaf 2

instead of on leaf 1.

4 = Enable

No = Disabled

F

+

Display

Function De-

fault

I

NDICATOR-LICHT:

If 0 is selected, the output functions

as a standard indicator-light (lighted

at opening and pause, flashing at

closing, and off when gate closed).

Different figures correspond to timed

activation of the output, which can be

used (via a relay) to power a courtesy

lamp. Time can be adjusted from 0

to 59s in 1s increments, and from 1.0

to 4.1 min. in 10s steps.

0 = Standard Indicator-Light

From 1 to 4.1 = Timed Output

C

LOSING PHOTOCELLS REVERSE AT RE-

LEASE

: Enable this function if you

want the closing photocells to stop

the gate movement and reverse it

after the beam is cleared. Default set-

ting is immediate reverse.

4 = Enable

No = Disabled

A.D.M.A.P. F

UNCTION:

If this function is enabled, the safety

devices operate in compliance with

French standard NFP 25/362.

4 = Enable

No = Disabled

A

SSISTANCE REQUEST (COMBINED WITH

NEXT FUNCTION): If activated, at the

end of countdown (settable with the

next function, i.e. “Cycle program-

ming”) it effects 8s of pre-flashing at

every Open pulse (job request). Can

be useful for setting scheduled main-

tenance jobs.

4 = Enable

No = Disabled

C

YCLE PROGRAMMING:

For setting count down of system

operation cycles. Settable (in thou-

sands) from 0 to 99 thousand cycles.

The displayed value is updated as

cycles proceed. This function can be

used to check use of the board or to

exploit the “Assistance Request” func-

tion

.

E

XIT PROGRAMMING:

Exit from programming and return to

display of inputs status.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 27 28

Comments to this Manuals

No comments