Controlled-products-systems-group 1812-087 User Manual download pdf (Page 24)

Page 24 1812-065-M-3-07

2.2 PC PROGRAMMING SET-UP

Prior to programming the 1812 with the DoorKing Auto-Programming Software for Windows, the

system must have the MASTER CODE and SYSTEM SET-UP information programmed into it.

These programming functions cannot be set with the PC and must be programmed from the system

keypad.

2.2.1 Master Code

This programming step sets the system MASTER CODE. The master code is the four-digit number

required to gain access to the system memory.

NOTE: The master code cannot be programmed from an off-site location. The master code

can only be programmed from the system keypad.

Factory setting = Last 4-digits of the serial number.

1. Open the cabinet of the telephone entry system and turn the master code switch (the

small toggle switch) on.

2. Enter a four-digit master code _ _ _ _ then press * (beep).

3. Turn the master code switch off and close the cabinet.

2.2.2 System Set-up Code

These steps will program the system set-up code. The system set-up code is a four-digit number that

will program the 1812 for: 1st digit) single or multiple systems on the phone line, 2nd digit) the units

attention number, 3rd digit) the number of rings to the house allowed before the system hangs up, 4th

digit) single or double ring to the house. You will need to enter a four-digit number in step 2 (see chart

below) to set the system set-up code.

The factory default code setting is 1 7 3 1.

1. Press * 0 4 and then enter the four-digit MASTER CODE _ _ _ _ (beep).

2. Enter the four-digit SET-UP CODE _ _ _ _ and then press * (beep).

3. Press 0# TOGETHER to end this programming step (beeeeeep).

Digit

Step 2

Valid Function

Entries

1 st 0 or 1 Enter 1 for a single system, or enter 0 when multiple systems are sharing the

phone line.

2 nd 0 – 9 Unit attention number.

3 rd 2 – 9 Number of rings to the house before the unit hangs up.

4 th 0 or 1 Enter 0 for the standard long ring, or enter 1 for the double ring.

STOP!!

If the telephone entry system is to be programmed from a PC, no other programming is required at

the system itself. Complete the 1812 programming using the Auto-Programming Software. However

– if the 1812 IS NOT on a shared phone line, then you must program Sections 2.3.5 and 2.3.6. If you

are not programming the 1812 using the software, continue with the remaining sections in this

manual.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 46 47

No comments

Controlled-products-systems-group 1812-087 User Manual Page 24