Controlled-products-systems-group 1812-087 User Manual download pdf (Page 36)

Page 36 1812-065-M-3-07

4.3 Preprogrammed Numbers

To use the preprogrammed phone number feature, the guest simply presses 01, 02, or 03 on the

system keypad. The 1812 will automatically dial out the specific preprogrammed phone number.

Once the call is answered at the other end, that party may grant or deny a guest access by pressing

the programmed tone open number or simply hanging up. NOTE: These numbers are different than

the call forwarding number.

1. To call the first preprogrammed number, press 01 on the keypad.

2. To call the second preprogrammed number, press 02 on the keypad.

3. To call the third preprogrammed number, press 03 on the keypad.

4.4 Entry Codes

The four-digit entry codes will operate either relay 1 or relay 2 depending on the location code that the

particular four-digit code has been stored under. The specific operation of the code is also dependent

on the location code used (see 2.6.1).

1. Press # .

2. Enter the four-digit entry code _ _ _ _ .

When the entry code is entered on the keypad, the system will check its memory to see if the code

entered is stored and under which location code it has been stored. If the entry code is stored under a

momentary activation location code, either relay 1 or relay 2 will activate for the programmed strike

time depending on which location code the entry code was stored under. If the entry code is stored

under a hold location code, the specific relay will latch on until another entry code is entered on the

keypad.

If the entry code entered is stored under a time zoned location, the system will first check to see if the

entry code time zone is turned on or turned off. If this time zone is turned off, the entry code will

activate the specific relay for the programmed strike time. If the entry code time zone is turned on, the

system will check the clock to determine if the entry code is within the time zone boundary. If the

entry code is within the time zone boundary, the respective relay will activate for the programmed

strike time. If the entry code is outside of the time zone boundary, the relay will not activate.

If the entry code is stored under a flash location, the system will check the clock to determine if the

current day is the programmed operating day for the entry code. If the current day is valid, the

respective relay will operate for the programmed strike time. If the current day is not valid, the relay

will not operate. Once the programmed operating day is past, the flash entry code will not work unless

a new flash operating day is programmed into the system.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 46 47

No comments

Controlled-products-systems-group 1812-087 User Manual Page 36